Resource: Consumable - DLF 3D printing resin: SubG+   Event history   Incoming Value Flow
Quantity 3.28 Volume - L
Current Location Sensorica Main Lab

Product Description

SubG+ was designed with a few things in mind: PDMS friendly, fast curing, low shrink. We’re pleased to say we’ve met these goals, with measured shrink <3.5%! The trade-off is higher viscosity (90cP at 25°C compared to SubG which is 12cP), but the benefit is it holds pigment for longer without as much settling.

SubG+ is available in two sizes (500mL / 0.5KG and 1L / 1KG). Finished prints are tough but not brittle due to our custom resin formulations.

SubG+ cures under UV A, B, and C light up to around 420nm. You can cure it with a DLP projector, a UV laser, or UV leds. When using UV lasers or LEDs, the cure time is extremely fast, so you don’t need much power.

This resin is low odor, zero VOC, and only mildly irritant. Unlike some bigger resin producers who say low odor/low VOC, you can sit right next to ours and not need a gas mask.

This resin will not effect PLA, but will cause degradation in ABS when uncured.

Each batch of resin we make is quality tested to ensure you get the best quality resin, at a great price!

Access Rules

Need to be a SENSORICA active affiliate. See more with managers

Assignments Custodian : SENSORICA
Manager : Tibi (Contact)
Manager : Daniel (Contact)
Record created date March 10, 2014
Record created by None

Where from:

We don't know.

Where to: