Feb. 26, 2014 |
Time Contribution |
Tibi |
Work - Programming software |
2.00 HR |
|
Documented the work, installed drivers for the USB device and discussed about the software commands and the next development steps. We are doing this for the Piezo application.
|
Make Prototype DAQ Jonathan
|
Prototype Material - DAQ card : Prototype DAQ Jonathan
|
July 31, 2013 |
Time Contribution |
Tibi |
Work - Training others |
0.50 HR |
|
helped Andy starting his work on the DAQ card driver. We identified resources and we did some planning. I sent Andy an email with details. Andy was at the lab.
|
|
|
July 23, 2013 |
Time Contribution |
Frederic |
Work - Documenting |
2.00 HR |
Open
|
Documenting the work on the DAQ card (PropDAQ Module)
|
|
|
July 23, 2013 |
Time Contribution |
Tibi |
Work - Meeting |
1.00 HR |
|
Meeting with Andy and Antonio to decide on what Andy can work. We closed in for the DAQ project, writing a LabView driver in C++ for integration with all the other instruments.
|
|
|
June 3, 2013 |
Time Contribution |
Frederic |
Work - Programming software |
20.00 HR |
|
PropMeter Data Acquisition software for the DAQ Card Prototype, written in Python.
|
|
|
June 3, 2013 |
Time Contribution |
Frederic |
Work - Programming software |
15.00 HR |
|
Internal firmware for the Propeller chip in the DAQ card, written in Spin and assembly.
|
|
|
May 1, 2013 |
Time Contribution |
Frederic |
Work - R&D electronics |
10.00 HR |
Open
|
Build DAQ Card prototype. Includes testing and debugging.
|
Make DAQ prototype
|
Prototype Material - DAQ card : DAQ Card Prototype FD
|
April 8, 2013 |
Time Contribution |
Frederic |
Work - Design Electronics |
20.00 HR |
|
Design of Propeller-based DAQ card. Includes electronic design, PCB layout and mechanical design. Went through 2 Revs to get good design.
|
Make DAQ Electronic Design
|
Design Electronic - DAQ card: PropDAQ Rev2 Schematic
|